YETI XD™ (30mm) Replacement Boot Seal (Tie-Rod and Drag Link)
YETI XD™ (30mm) Replacement Boot Seal (Tie-Rod and Drag Link)
$ 17.99

YETI XD™ (30mm) Replacement Boot Seal (Tie-Rod and Drag Link)

Customer Reviews

Based on 27 reviews
63%
(17)
15%
(4)
7%
(2)
7%
(2)
7%
(2)
J
Jeran Mclain
Tie rod boot

So I ordered the tie rod boot and it was 5 days late from the day it was suppose to arrive and I wasnt happy until I contacted customer service and they did not hesitate to take care of me and that's more important than anything to me. Great job Steer Smarts.

S
Steve Friend
replacement

So, it was determined that I made a mistake in tightening the joint down. But, with the new replacement, found that the end of the boot was going to be trapped between the pivot and the red washer again. I determined that the boot has to be located above or around the actual pivot. I move the boot up and around the pivot and secured it in place. No where are there instructions to go this.

G
Gary Russell
Great boot

Easy install after removal and cleanup anyway. The install tool did the job, but I bet I will get better next time.

P
PW Coon
Boot

Installation was VERY easy!!! I used the installer long cup for my ball joint c clamp install tool. The cup fit perfectly around the install cap that Steer Smarts provided. Took longer to take the tire off that to install the tie-rod boot. FAST shipping also.

J
Jae Bae
Great part! Bad installation tool.

Damaged my boot seal during my last run at Valley Fair Mall in San Jose. This is a tough trail.

Installation tool collapsed immediately.

3D printed basic cylinder with hole in the middle for the bolt/nut to go though for clamping action. Even with 20% infill, the tool survived the installation. Got it installed in 30 mins.

Replacement YETI XD™ Boot Seal (30mm)

Compatible with Tie-Rod and XD Drag Link.

Part # 53036002 

 Installation

Customer Reviews

Based on 27 reviews
63%
(17)
15%
(4)
7%
(2)
7%
(2)
7%
(2)
J
Jeran Mclain
Tie rod boot

So I ordered the tie rod boot and it was 5 days late from the day it was suppose to arrive and I wasnt happy until I contacted customer service and they did not hesitate to take care of me and that's more important than anything to me. Great job Steer Smarts.

S
Steve Friend
replacement

So, it was determined that I made a mistake in tightening the joint down. But, with the new replacement, found that the end of the boot was going to be trapped between the pivot and the red washer again. I determined that the boot has to be located above or around the actual pivot. I move the boot up and around the pivot and secured it in place. No where are there instructions to go this.

G
Gary Russell
Great boot

Easy install after removal and cleanup anyway. The install tool did the job, but I bet I will get better next time.

P
PW Coon
Boot

Installation was VERY easy!!! I used the installer long cup for my ball joint c clamp install tool. The cup fit perfectly around the install cap that Steer Smarts provided. Took longer to take the tire off that to install the tie-rod boot. FAST shipping also.

J
Jae Bae
Great part! Bad installation tool.

Damaged my boot seal during my last run at Valley Fair Mall in San Jose. This is a tough trail.

Installation tool collapsed immediately.

3D printed basic cylinder with hole in the middle for the bolt/nut to go though for clamping action. Even with 20% infill, the tool survived the installation. Got it installed in 30 mins.